QE20 Fibre Networking User Manual Document: LT0732
Page 8-2 24 May 2023 Issue 1.0
8.1.3 Configuring a Replacement PIB.
Refer to the PIB User Manual (LT0519) for full instructions.
The PIB needs to have V4.0 firmware or later installed for compatibility with QE20. It
should be configured as per the documentation pack. Instructions are contained in
Section 3.9.
8.1.4 Configuring a Replacement Fibre Switch.
Refer to the PIB User Manual (LT0519) for instructions.
The Fibre Switch should be configured correctly as per the documentation pack, or
the saved configuration restored. Refer to Section 3.10.
To Previous Page
Loading...
