Viking Designer Ruby - Accessories Included - Not in the Picture; Presser Feet

1:8
PRESSER FEET
7
Utility Foot A
Snapped onto the machine upon delivery. This foot is used mainly for straight stitching and
zigzag stitching with a stitch length longer than 1.0.
7
Decorative Stitch Foot B
For sewing close zigzag stitches (satin stitches) with less than 1.0 mm stitch length, other utility
stitches or decorative stitches, use this foot. The tunnel on the underside of the foot is designed
to feed smoothly over the stitches.
7
Buttonhole Foot C
For manual buttonholes. This foot has guide lines to determine buttonhole length. The middle
measures a 5/8'' (15 mm) from the fabric edge. The two tunnels on the underside of the foot
ensure a smooth feed over the buttonhole columns. The À nger on the back of the foot holds
cording for corded buttonholes.
Blindhem Foot D
This foot is used for blindhem stitches. The inner edge of this foot guides the fabric. The right
toe of the foot is designed to ride along the hem edge.
7
Zipper Foot E
This foot can be snapped on either to the right or to the left of the needle. This makes it easy to
sew both sides of the zipper. Move needle position to right or left to sew closer to zipper teeth
or for covering large cording.
7
Non-Stick Glide Foot H
This foot, with a non-stick coating underneath, is used when sewing foam, vinyl, plastic, or
leather to keep these materials from sticking to the foot.
ACCESSORIES INCLUDED - Not in the Picture
• 5D™ Embroidery Machine Communication CD
• Carrying Case (attached on the machine upon delivery)
• Scissors
• Foot control
• Power cord
• USB PC cable
• Needles
• Embroidery thread
• Pieces of fabric and stabilizer
• DESIGNER RUBY™ Sampler book
• User’s Guide
• Warranty card