48 - ENGLISH
6.6.3
Wait for the LED to turn red (after about
15 seconds), then insert the MASTER
smart card to enable the procedure.
If the MASTER smart card is not inserted
within 15 seconds, the LED turns off and
the device exits the procedure.
MASTER
card
MASTER
card
If the LED blinks red it means the
MASTER smart card was not recognised.
Remove the incorrect smart card and
insert the correct one.
MASTER
card
MASTER
card
6.6.4
If the MASTER smart card is recognised,
the LED switches off.
6.6.5
Remove the MASTER smart card.
The LED turns green, waiting for a SLAVE
smart card to program.
MASTER
card
MASTER
card
SLAVE
card
SLAVE
card
6.6.6
Insert the SLAVE smart card to be pro-
grammed as a duplicate.
The device waits for a smart card to pro-
gram for about 15 seconds, after which it
exits the procedure.
Exiting is signalled by the LED switch-
ing off.
6.6.7
When the LED turns off, the duplicate
SLAVE smart card has been pro-
grammed.
To Next Page
Loading...
