ITALIANO - 33
5.4.8
Remove the smart card.
The LED turns green, waiting for addition-
al smart cards to program as duplicates.
To program additional duplicate smart
cards, repeat the procedure from step
5.4.6.
5.4.9
To exit the procedure, press the front
button.
The LED switches off.
If no smart cards are inserted for about
15 seconds, the procedure automatically
terminates.
Exiting is signalled by the LED switch-
ing off.
5.5 Cancelling
SLAVE
smart cards
This procedure is used for cancelling smart cards.
Warning! At least one smart card must be left enabled, in
order to continue accessing the system procedures.
5.5.1
Press the front button.
The LED blinks in the sequence red-off-
green.
5.5.2
Press the front button again. The LED
turns yellow.
To Next Page
Loading...
Need help?
General
