ENGLISH - 15
4.
Smart car reader operation without a
configurator
• A MASTER smart card is needed to perform any operation
(initialising, programming, duplicating, cancelling, changing
the code, synchronising readers).
To ensure correct operation, carry out the following steps in
the order given:
• storing MASTER smart cards in memory
• associating a relay (to be done after setting the dip
switches)
• storing SLAVE smart cards in memory
Device and access control in the hotel
sector:
4.1
Initialising the reader and pro-
gramming MASTER smart cards
This procedure generates a MASTER code in the memory of
the reader/programmer being initialised, and copies it to the
desired MASTER smart cards.
Important! During this phase, always program several
copies of the MASTER smart card (to be kept in a safe
place), because it will not be possible to make dupli-
cates at a later time.
4.1.2
Select the “Hotel” address
1 2 3 4 5 6 7 8
ON
1
O
N
2 3 4 5 6 7
4.1.1
Power up the reader.
To Next Page
Loading...
