ENGLISH - 39
6.3 Initialising the reader and pro-
gramming or reprogramming
SLAVE smart cards
This procedure generates a SLAVE code, associates it with
the address selected by the dip-switches on the reader/
programmer being initialised, and copies it to the desired
smart cards.
To carry out this procedure it is necessary to have the
MASTER smart card (see paragraph 6.1).
1 2 3
ON
6.3.1
Place dip-switch 1 in the ON position.
The LED lights up yellow.
6.2.8
To exit the procedure, place dip-switch
2 in the OFF position. The LED switches
off.
1 2 3 4
ON
6.2.7
Remove the smart card, the LED turns
green again, waiting for other smart cards
to reprogram.
To reprogram additional MASTER smart
cards, repeat the procedure from step
6.2.5.
To Next Page
Loading...
