VIPA System 300S - Page 5

7.4 Parametrization.............................................................. 182
7.4.1 FC/SFC 216 - SER_CFG - Parametrization PtP......... 182
7.5 Communication.............................................................. 183
7.5.1 FC/SFC 217 - SER_SND - Send to PtP...................... 183
7.5.2 FC/SFC 218 - SER_RCV - Receive from PtP............. 183
7.6 Protocols and procedures ............................................. 183
7.7 Modbus - Function codes .............................................. 187
7.8 Modbus - Example communication................................ 192
8 Deployment PROFIBUS communication........................... 194
8.1 Overview........................................................................ 194
8.2 Fast introduction............................................................. 195
8.3 Hardware configuration - CPU....................................... 195
8.4 Deployment as PROFIBUS DP master.......................... 196
8.5 Deployment as PROFIBUS DP slave............................ 197
8.6 PROFIBUS installation guidelines.................................. 200
8.7 Commissioning and Start-up behavior........................... 203
9 WinPLC7............................................................................... 205
9.1 System conception......................................................... 205
9.2 Installation...................................................................... 205
9.3 Example project engineering.......................................... 207
9.3.1 Job definition............................................................... 207
9.3.2 Project engineering..................................................... 207
9.3.3 Test the PLC program in the Simulator.......................
213
9.3.4 Transfer PLC program to CPU and its execution........ 214
10 Configuration with TIA Portal............................................. 216
10.1 TIA Portal - Work environment .................................... 216
10.1.1 General..................................................................... 216
10.1.2 Work environment of the TIA Portal.......................... 216
10.2 TIA Portal - Hardware configuration - CPU ................. 217
10.3 TIA Portal - Hardware configuration - I/O modules...... 218
10.4 TIA Portal - Hardware configuration - Ethernet PG/OP
channel......................................................................... 219
10.5 TIA Portal - Setting VIPA specific CPU parameters..... 222
10.6 TIA Portal - VIPA-Include library................................... 225
10.7 TIA Portal - Project transfer.......................................... 226
VIPA System 300S Table of contents
HB140 | CPU | 314-6CF03 | GB | 16-43 5