VIPA System 300S - Cabling

9. Click the CPU downwards and bolt it like shown.
10. Repeat this procedure with the peripheral modules, by clicking a
backplane bus connector
, stick the module right from the
modules you've already fixed, click it downwards and connect it
with the backplane bus connector of the last module and bolt it.
3.5 Cabling
CAUTION!
– The power supplies must be released before instal-
lation and repair tasks, i.e. before handling with the
power supply or with the cabling you must discon-
nect current/voltage (pull plug, at fixed connection
switch off the concerning fuse)!
– Installation and modifications only by properly
trained personnel!
VIPA System 300S Assembly and installation guidelines
Cabling
HB140 | CPU | 314-6CF03 | GB | 16-43 25