What to do if warning lights are flashing on my Viper Scrubber?
If the warning lights are flashing on your Viper Scrubber, it indicates that the brush motor is overloaded, consider changing to a soft brush to adapt to the floor being cleaned. It may also indicate that there is an obstruction preventing the brush from spinning, so clear the brush.
Why is the brush not working on my Viper AS510B?
If the brush is not working on your Viper Scrubber, the brush fuse may have tripped off, so reset it. Alternatively, the belt might be slipping, so check the belt and adjust the tension.
Why is the water supply to the brush inadequate on my Viper AS510B Scrubber?
If the water supply to the brush is inadequate on your Viper Scrubber, the filter might be dirty, so clean the filter.
Why is the vacuum motor not working on my Viper Scrubber?
If the vacuum motor is not working on your Viper Scrubber, the vacuum fuse may have tripped off. In this case, reset it.
Critical safety warnings and precautions for operating the machine.
Identifies all machine components via an exploded view and control panel layout.
Procedures for safely replacing the machine's batteries.
Instructions for configuring the machine for WET, GEL, or AGM batteries.
Step-by-step guide for starting and safely stopping the machine.
Basic operational procedures for scrubbing and maneuvering.
A comprehensive table of routine maintenance tasks and their frequencies.
Instructions and important precautions for charging the machine's batteries.
General| Model | AS510B |
|---|---|
| Category | Scrubber |
| Power Source | Battery |
| Scrubbing width (mm) | 510 |
| Motor power brush (W) | 450 |
| Brush pressure (kg) | 23 |
| Brush speed (RPM) | 150 |
| Sound level (dB(A)) | 69 |
| Battery Voltage | 24 |
| Charger included | Yes |
| Battery type | Lead-acid |
| Brush Width | 510 mm |
| Cleaning Path | 510 mm |
To Next Page
