Vishay G4 - Zeroing and Offset Settings; Setting the Scale Zero; Understanding Zero Offset

Operating instructions, Quick installation
1:Set Zero
This parameter is used to make the scale display gross weight zero when it is
unloaded. Make sure the scale is completely unloaded before this setting is performed.
Press key ↵ .
The current gross weight is displayed as a live weight.
Press key ↵ .
The value +000000.00 kg is proposed for '1:Set Zero'.
Press key ↵ for 1 second to accept 0.00 kg.
The zero setting is now finished.
Press key + to display next parameter.
1:Zero Offset
1
:Set Zero
0.00 kg
Gross Weight:
014.28
1:Set Zero
+000000.00 kg
1:Set Zero
0.00 kg
This parameter shows the offset value, needed to make the scale display the gross
weight 'zero' for unloaded scale.
The value of '1:Zero Offset' should not be edited.
Press key + to see actual gross weight.
This display of live gross weight gives
the possibility to check the load on the scale
at any moment during the calibration.
Press key + to see actual transducer signal.
This display of live transducer signal gives
the possibility to check the signal at any moment
during the calibration.
1:Zero Offset
14.28 kg
Gross Weight:
xxx.xx
Transd. Signal:
x.xxxxx mV/V
30