NEXT CAM PG2, NEXT-K9 CAM PG2
18 D-302758
4
For optional mains
power supply:
Break the cable entry
knockout and insert
the mains cable.
Cable entry
knockout
5
Press the base against the wall at the
selected mounting position and mark
the drilling points through the mounting holes
6
Drill 2 holes or 3 holes
(for back tamper) and
attach the base to the
wall using the screws
MOUNTING
KNOCKOUTS
(3 of 6 -
for corner
mounting)
MOUNTING
KNOCKOUTS
(for surface
mounting)
BREAK-AWAY
BASE SEGMENT
(SHADED)*
BR-1
Knockout
*CAUTION! THE BACK TAMPER SWITCH WILL
NOT PROTECT THE UNIT UNLESS THE BREAK-
AWAY BASE SEGMENT IS SECURED TO THE
WALL WITH AT LEAST ONE SCREW.
7
Slide the external power adaptor circuit
into its connector
Power adaptor circuit connector
Figure 5b. Mounting on Wall
To Next Page
Loading...
