MC-302 PG2
34 D-302758
D. After 2 seconds the LED blinks 3 times.
The following table indicates received signal strength indication.
LED response Reception
Green LED blinks Strong
Orange LED blinks Good
Red LED blinks Poor
No blinks No communication
IMPORTANT! Reliable reception must be assured. Therefore, "poor" signal strength is not acceptable. If you
receive a "poor" signal from the device, re-locate it and re-test until a "good" or "strong" signal strength is
received.
Note: For detailed Diagnostics Test instructions refer to PowerMaster-10 Installer Guide.
7. MISCELLANEOUS COMMENTS
Visonic Ltd. wireless systems are very reliable and are tested to high standards. However, due to low
transmitting power and limited range (required by FCC and other regulatory authorities), there are some
limitations to be considered:
A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of
the digital code used.
B. A receiver responds only to one transmitted signal at a time.
C. Wireless devices should be tested regularly to determine whether there are sources of interference and to
protect against faults.
The user is cautioned that changes or modifications to the unit, not expressly approved by Visonic Ltd.,
could void the user’s FCC or other authority to operate the equipment.
To Next Page
Loading...
