RP-610 PG2
36 D-302758
1
2
3
(*)
4
For back
tamper screw
6
5
AC to AC
adaptor
Figure 2 - Installation
.
4. ENROLLMENT
Refer to the PowerMaster-10 Installer Guide for the device enrollment procedure.
5. CONFIGURATION AND OPERATION
5.1 Service Messages
Five kinds of event codes are automatically included in a service transmission in addition to the repeater’s:
O
AC fail
O
Low Battery
O
End of life
O
Tamper
O Supervision
.
Upon power failure, recharging stops and the backup battery takes over. It is therefore correct to assume that
without power input the battery is gradually weakening and may be reported as “low”.
Power / battery restore is reported only in the following test report.
End of life is reported when battery power is depleted and device is about to shut down.
Tamper restore is reported immediately upon occurrence.
If the tamper or power failure condition persists long enough, respective alerts will be sent out again with each
test report.
RP-600 PG2
REPEATER
POWERMASTER-10
CONTROL PANEL
Keyfob
Door or window
open/close detector
Motion detector
Siren
Figure 3: Repeater Configuration
To Next Page
Loading...
