VMI CUBE - Declaration of Conformity

93
DECLARATION OF CONFORMITY
Ventilairsec declares that the VMI
®
CUBE VISION’R unit is conform:
• Directive 2014/30/EU on electromagnetic compatibility
• Directive 2014/35/EU on low voltage electrical equipment
• Directive 2014/53/EU on radio equipment
• Directive 211/65/EU on the restriction of the use of hazardous substances in electrical
and electronic equipment
The main applicable requirements of the RED directive 2014/53/EU
• EMC:
o ETSI EN 301 489‐3: 2019 V2.1.1 with standard ETSI EN 301 489‐1: 2019 V2.2.3:
Short-range devices operating in the 9 kHz to 246 GHz frequency range
o EN 55014-1 2017: Mains-powered devices
o EN 55014‐2: 2015: Category 4 devices (F>15 MHz)
o EN 61000‐3‐2: 2006 / A1: 2009 / A2: 2009: Limits for harmonic current emissions
o EN 61000‐3-3: 2013: Limitation of voltage changes, voltage fluctuations and
flicker in public low-voltage supply systems, for equipment with rated current
inferior or equal to 16 A per phase and not subject to conditional connection
• Radio frequency:
o EN 300220-2 V3.1.1
o EN 300328 V2.1.1
• EMF EN 62479 (2010)
• Low voltage:
o EN 60335-2-30:2009 + A11:2012
o EN 60335-2-80:2003 + A1:2004 + A2:2009
o EN 60335-1:2012 + A11:2014 + A13:2017
o EN 62368-1:2014
Ventilairsec confirms that the EMC, EMF, Radio and Electrical safety tests have been performed
by a certified body. The official declaration of conformity is available upon request.
The EC marking is placed on the product - year: 2023
Ventilairsec confirms that the VMI
®
CUBE VISION’R unit complies with the ground continuity and
dielectric strength tests.
A test has been performed on this product to validate the essential safety aspects in accordance
with Appendix A of the NF EN60335-1:2012 standard. These routine tests are carried out by
Ventilairsec on each VMI
®
unit that leaves their production plants in order to detect any
production variations that could affect the safety of the products. These tests are performed on
the completed VMI
®
unit ready to ship, as recommended by the standard.