VOLCON BRAT OWNER’S MANUAL
pg. 25
Fender Installation
FRONT FENDER
Figure 11 - Front Fender Installation
1. Secure front fender bracket, with a 3mm screw to the lower triple tree, in front
of the lower triple tree.
2. Use the 3mm Allen wrench to torque the screw to 1.47 ft lbs (2.00 Nm).
REAR FENDER
Figure 12 - Rear Fender Installation
1. Locate the mounting site under the seat to the rear, push the rear fender into
the slot, and pull the fender to the rear of the bike.
2. Align the holes and install 2 x 3mm bolts.
3. Use the 3mm Allen wrench to torque the screws at 1.47 ft lbs (2.00 Nm).
To Next Page
Loading...