pg. 26
VOLCON BRAT OWNER’S MANUAL
Headlight Installation
Figure 13 - Headlight Installation
1. Remove the mounting bolts from the headlight using the 14mm box wrench.
2. Loosen the headlight bracket bolts using the 4mm Allen wrench.
3. Slide the headlight in between the mounting brackets with the wire connection
pointing down.
4. Secure the headlight to the mounting brackets using the mounting bolts from
the headlight, then plug into the wire harness.
5. Torque the headlight mounting bolts at 7.37 ft lbs (10.00 Nm) using the 14mm
box wrench.
6. Tighten the headlight bracket bolts using the 4mm Allen wrench.
To Next Page
Loading...