pg. 60
VOLCON BRAT OWNER’S MANUAL
Seat
It is not possible to adjust the seat height of the Brat. It is xed to the frame by bolts. The
minimum seat clamping torque on the frame is 3.00 ft lbs (4.07 Nm). For maintenance,
use a cloth and water with gentle soap for cleaning. Avoid leaving in direct sunlight for
long periods of time as this can damage the seat. Avoid wearing clothes or objects that
may puncture or tear the seat.
Suspension
Suspension components will require regular maintenance, cleaning, and greasing
in order to keep the movement of the use components in good working order. It is
recommended to inspect each component of the suspension for signs of wear regularly.
WARNING: FAILURE TO MAINTAIN, CHECK AND PROPERLY ADJUST THE
SUSPENSION SYSTEM MAY RESULT IN SUSPENSION MALFUNCTION, WHICH
MAY CAUSE YOU TO LOSE CONTROL AND FALL.
WARNING: THE BIKE IS SUBJECT TO WEAR AND TEAR, LIKE ALL
MECHANICAL PARTS. MATERIALS AND PARTS REACT DIFFERENTLY TO
WEAR AND ABRASION. IF THE INTENDED LIFE OF A PART IS EXCEEDED, IT IS
POSSIBLE THAT IT WILL SUDDENLY FAIL, WHICH REPRESENTS A CERTAIN
DANGER FOR THE RIDER. ANY TYPE OF CRACKS, STREAKS, OR COLOR
CHANGES IN HIGHLY STRESSED AREAS INDICATES THE MAXIMUM WEAR OF
A PART. THEREFORE, BE REPLACED IMMEDIATELY. IT IS IMPORTANT TO USE
GENUINE VOLCON-APPROVED PARTS FOR SAFETY-CRITICAL COMPONENTS
DURING THE REPLACEMENT OF WORN PARTS.
To Next Page
Loading...