pg. 30
VOLCON BRAT OWNER’S MANUAL
Charger
Figure 19 - Charger
NOTE: The charger is a switched-mode power supply so it will work with both
100v - 240v.
How to install the battery in the bike
• Use the battery key to unlock the battery from the frame to remove battery.
• Disconnect the battery from the battery holder by sliding the battery up and
pulling away from the frame.
Q Quick Tip: We recommend charging the battery for 6-8 hours on the rst charge.
This will help balance the lithium-ion cells for optimal performance.
We also recommend powering off the bike, then powering off the
battery when the bike is not in use. Remove the battery from the
bike when storing the bike or not using the bike for extended periods
of time.
To Next Page
Loading...