VOLCON BRAT OWNER’S MANUAL
pg. 33
NOTE: Make sure the brakes are applied before getting on to your bike. If the
pedal assist mode is turned on, the e-bike will start moving as soon as you
push on the pedal. This unfamiliar push can otherwise cause a fall, hazard, or
accident. Applying the brake will disable the assistance mode.
ENSURE POWER IS OFF
Mount bike rst BEFORE powering or applying throttle. If either brake is applied
as you power your bike, the display will show an Error.
Code E005 - This code will immediately disappear once the brake is released.
If the error code remains on the display, refer to Table 6. (pg. 62)
PRE-RIDE SAFETY CHECK
To Next Page
Loading...