93
3. Restarting the measurement with the same period
Proceed as follows to start another measurement with the
previously set period:
Briey press the button; the display shows PERIOD
and the current period setting for the measurement.
Briey press the button: the day ashes on the dis-
play.
Briey press the button: the hours ash on the dis-
play.
Briey press the button: the setup mode is exited
and the display does not ash.
Briey press the button to start the measurement.
4. Early aborting the measurement
Briey press the button for the display to show the
current time setting.
Press and hold the button for 3 seconds until the
normal display is shown.
When the ashing PERIOD disappears, the measure-
ment has been aborted.
To Next Page
Loading...
