Volvo Penta D1-13 - Page 126

Reassemble
5 Apply 828250 Grease
on the seal rings (1a, 1b).
Install seal rings, O-ring (2) and spacer washer
(3) according to the illustration.
NOTICE! The last seal ring (1a) shall align with
the surface of the pump housing (4).
6 Carefully press on the first ball bearing (1) behind
the groove for the retainer ring.
Install the retainer ring (2) and spacer sleeve (3).
CAUTION!
Risk of eye injury. Eye protection required.
Carefully press on the second ball bearing (4).
Press the first ball bearing back until it is abut the
retainer ring.
1b
1a
2
3
4
P0018146
2
134
P0018147
26-6 Sea Water System, Sea Water Pump
124 47701798 05-2013 © AB VOLVO PENTA