Flywheel, Change
1 Remove the engine rpm sensor (1
) and filter
housing bracket (2).
Remove the flywheel cover (3) and flexible cou-
pling.
2 Unbolt the flywheel (1) and remove it.
Clean and check the crankshaft seal.
3 Carefully clean the crankshaft and flywheel.
Install the new flywheel and tighten it to the speci-
fied torque; refer to Tightening torques page 9.
Install the flexible coupling, flywheel housing, fil-
ter housing bracket and engine rpm sensor.
21-5 Timing Gears and Shaft
47701798 05-2013 © AB VOLVO PENTA 87
To Next Page
Loading...
