21-0 Engine Complete, General
Exposing the Engine
Before lifting the engine
Boat removed from the water
1
Turn the battery isolator off, and undo the battery
connections on the starter motor.
2
Remove the harness terminal for the engine instru-
mentation harness.
3 Remove the raw water connections / keel cooling
connection.
4 Remove the exhaust line.
5 Close the fuel taps. Remove the fuel connections.
6 Remove the throttle and gear shift cables.
7 Undo the propeller shaft from the reversing gear.
Undo the engine mounting pads from the bed and
lift the engine out. Use the lifting lugs (1) on the
engine.
Actions after lifting the engine
1 Clean the engine.
IMPORTANT!
Remember
the
following when washing with a power
washer: Be extremely careful when cleaning, to
avoid getting water inside engine components.
When a power washer is used, the water jet must
never be aimed at seals, such as shaft seals, joints
with gaskets, rubber hoses or electrical components.
2 Drain the engine oil
3 Remove the reverse gear (as necessary)
21-0 Engine Complete, General
47701798 05-2013 © AB VOLVO PENTA 49
To Next Page
Loading...
