SECTION 5 MAINTENANCE INSTRUCTIONS
5-28 DD-29/31HF/38HF Vibratory Asphalt Compactors
9. Allow air to escape until bubbles no longer appear. Close air vent cock
(1, Figure 5-35) and return the ignition key to the STOP position.
10. Wipe up any fuel that has escaped and check for leaks.
Purge Lube Carrier
1. Park the machine on a level surface.
2. Clean the area around the protective cap (1, Figure 5-36) on the grease fitting
of each drum.
Figure 5-36
3. Remove the caps and apply MPG-EP2 grease to the grease fitting as required.
4. Wipe off excess grease and install protective caps.
To Next Page
Loading...
