FUEL AND LUBRICANT SPECIFICATIONS SECTION 8
DD-29/31HF/38HF Vibratory Asphalt Compactors 8-3
1. Thoroughly wash all fittings, caps, plugs, etc. with non-flammable, non-toxic
cleaning solution before servicing, to prevent dirt from entering while
performing the service.
2. Lubricants must be at operating temperature when draining.
3. During regular lubrication service, visually check the entire unit in regard to
capscrews, nuts and pins being properly secured.
4. Spot check several capscrews and nuts for proper torque. If any are found
loose, a more thorough investigation must be made.
5. If a defect is detected which requires special maintenance service, stop the
machine operation until the defect has been corrected. If necessary, contact
the local distributor for assistance.
6. This symbol represents an area where lubrication is required.
Periodic lubrication requirements are listed in the following Lubrication Chart. These
requirements include lubricant checks and greasing designated areas of the machine.
To Next Page
