SECTION 1 SAFETY
1-10 DD-29/31HF/38HF Vibratory Asphalt Compactors
ALWAYS USE the correct tools and workshop equipment when performing maintenance to
the machine.
ALWAYS USE specially designed or otherwise safety oriented ladders and working platforms
when doing overhead assembly work. Never use machine parts as a climbing aid.
KEEP all handles, steps, handrails, platforms, landings and ladders free from mud, dirt, snow
and ice.
CLEAN the machine, especially connections and threaded unions, of any traces of oil, fuel or
preservatives before carrying out maintenance/repair. NEVER use aggressive detergents.
Use lint free cleaning rags.
Before cleaning the machine with water, steam jet (high pressure cleaning) or detergents,
COVER OR TAPE up all openings which - for safety and functional reasons - must be
protected against water, steam, or detergent penetration. Special care must be taken with
electric motors and electronic equipment.
ENSURE during cleaning of the machine that temperature sensors do not come into contact
with hot cleaning agents.
REMOVE all covers and tapes applied for that purpose after cleaning machine.
After cleaning, EXAMINE all fuel, lubricant, and hydraulic fluid lines for leaks, loose
connections, chafe marks and damage. REPAIR or REPLACE defective parts immediately.
Always TIGHTEN any screwed connections that have been loosened during maintenance and
repair.
Any safety devices removed for setup, maintenance or repair purposes must be refitted and
checked immediately upon completion of the maintenance and repair work.
ENSURE that all consumable and replaced parts are disposed of safely and within
environmental regulations.
AVOID, whenever possible servicing, cleaning, or examining the compactor with the engine
running.
AVOID, whenever possible, servicing or providing maintenance to the compactor unless the
drum and wheels are adequately chocked, parking brake applied and the articulation lock
bar/lock pin is in the locked position.
NEVER fill the fuel tank with the engine running, while near an open flame, or while smoking.
ALWAYS wipe up any spilled fuel.
DO NOT alter the engine governor settings from those indicated in the engine manual and the
engine option plate.
ALWAYS replace damaged or lost decals. Refer to the parts manual for the proper location
and part number for all decals.
ENSURE the safe operation, optimum performance, and safety of your warranty by using only
genuine manufacturer replacement parts.
To Next Page
Loading...
