WABCO OptiTire - Experts Report; Certificates; Atex; Radio Approvals

19
System description
5.4 Expert’sreport/certicates
RFcerticates:
– Open the WABCO INFORM online product catalogue
http://inform.wabco-auto.com
– Use the product name OptiTire or IVTM to search the desired certicates.
– If you have any questions, please contact your WABCO partner.
Expert’s reports / Certicates for mounting and additional mounting of OptiTire are available, which
signicantly facilitate approval of vehicle registration papers. Customers must also include the relevant
details in the operating instructions.
5.4.1 ATEX
As the WM2 has its own battery and is attached to the outside of the wheel, it falls under the ATEX
directive to be used as explosion-proof equipment for potentially explosive gas atmospheres up to zone
1. It fulls the relevant requirements.
Expert’sreport/certicate
 WM2: Associated EU type test certicate
TÜV 04 ATEX 2418 X
 Application area ADR (G: potentially explosive gas atmospheres):
II 2G Ex ib IIC T4
The device is rated as being a small piece of electrical equipment, and therefore the marking
does not contain the complete information in accordance with directives or standards. The
manufacturer of the sensor is WABCO GmbH, Am Lindener Hafen 21, 30453 Hanover.
5.4.2 Radio approvals
The OptiTire components contain a radio transmitter for the 433 MHz ISM waveband. The output power
is less than 1 mW. The following approvals are available:
Expert’sreport/certicate
 CE: 2014 / 53 / EU (RED)
 FCC: Part 15
 IC: RSS-210 Issue 8, RSS-GEN Issue 4, RSS-102 Issue 5