58
Requirements for start-up
Requirements for start-up
8 Requirements for start-up
8.1 Training
Entering a PIN is required for the parameter settings.
Having participated in a course of E-Learning, you can request a PIN for the Diagnostic Software from
us. You can then use this personal identication number to enable enhanced functions in the software
that allow you to modify the settings in electronic control units.
WABCO Academy – Registration for a training course / eLearning
– Open the myWABCO website:
https://www.am.wabco-auto.com/de/mywabco/welcome/
Help on logging in can be obtained by pressing the Step-by-step instructions button.
Once you have successfully registered and logged in you can book training courses and work
through E-Learnings via myWABCO.
Please contact your WABCO partner if you have any questions.
8.2 Diagnostic Software
With the Diagnostic Software you have the following options:
Retrieving the diagnostic memory data
Retrieving current measured values
Parameter setting
Display of measures to remedy faults (if faults are indicated).
The ECU settings can only be changed by trained workshop staff in the protected program
area.
Downloading the Diagnostic Software
– Open the myWABCO website:
https://www.am.wabco-auto.com/de/mywabco/welcome/
Help on logging in can be obtained by pressing the Step-by-step instructions button.
After successfully logging in you can download the desired Diagnostic Software (available in
various languages).
Please contact your WABCO partner if you have any questions.
To Next Page
Loading...
