Drivetrain CT Repair
wc_tx000554gb.fm 108
8.12.10 Remove the screws (54) from the side cover (7) and remove the side
cover. Inspect the O-ring (90) and replace it if it is worn.
8.12.11 For gearboxes with cup-and-cone–style brakes (a), press the brake
cup (22) from the side cover using a hydraulic press.
For gearboxes with disc-type brakes (b), press the brake disc (94).
from the side cover using a hydraulic press.
8.12.12 Remove the seal (32) from the cover.
8.12.13 Remove the spring (34) from the gearbox.
8.12.14 Remove the input shaft assembly (g) from the gearbox and remove the
spacer (35) from the input shaft assembly.
8.12.15 Using a hydraulic press, press the roller bearing (29) from the input
shaft.
8.12.16 Using a hammer-type gear puller (h), pull the needle bearing (30) from
the gearbox.
8.12.17 Clean the parts with an appropriate cleaning solvent.
8.12.18 Inspect all of the gears, bearings, O-rings, seals and shims for wear or
damage; replace any worn or damaged component.
To Next Page
Loading...
Need help?
General
