Wacker Neuson CT 48 Repair Manual

Clutch CT Repair
wc_tx000552gb.fm 76
6.7 Replacing the Variable Speed Clutch
See Graphic: wc_gr003383, wc_gr002068
Removal:
6.7.1 Remove the drive belt. See section Replacing the Drive Belt.
6.7.2 Remove the bolt (51) that secures the clutch (23) to the engine drive
shaft and slide the clutch from the engine drive shaft. Note: Use a gear
puller if necessary.
6.7.3 Remove the key (84).
6.7.4 Remove the bolt (58) that secures the clutch pulley (24) to the gearbox
input shaft and remove the clutch pulley.
6.7.5 Remove the key (132).
Installation:
6.7.6 Install the key (132) onto the gearbox input shaft.
6.7.7 Slide the clutch pulley (24) over the gearbox input shaft.
6.7.8 Apply Loctite 243 or equivalent to the bolt (58) and secure the clutch
pulley to the gearbox input shaft.
6.7.9 Install the key (84) onto the engine drive shaft.
6.7.10 Slide the clutch (23) over the engine drive shaft.
6.7.11 Apply Loctite 243 or equivalent to the bolt (51) and secure the clutch
to the engine drive shaft.

Wacker Neuson CT 48 Specifications

General

Brand	Wacker Neuson
Model	CT 48
Category	Trowels
Language	English