Drivetrain CT Repair
wc_tx000554gb.fm 102
8.9 Replacing the Gearbox
See Graphic: wc_gr003359
Removal:
8.9.1 Remove the handle. See section Replacing the Lower Handle.
8.9.2 Remove the spider. See section Removing the Spider.
8.9.3 Remove the clutch as described in section Replacing the Standard
Clutch.
8.9.4 Remove the screw (54) and the washer (70) from the pulley (24).
8.9.5 Remove the pulley (24) from the input shaft using a three-jaw puller.
Remove the key (82). Inspect the key and keyways for signs of
shearing. Replace the key if deformed or edges are rounded.
8.9.6 Remove the screws (50) that secure the beltguard plate (4) to the
engine and remove the beltguard plate.
8.9.7 Remove the engine as described in section Engine Removal.
8.9.8 Remove the screws (56) that secure the gearbox to the guard ring (1)
and lift the guard ring off of the gearbox.
Installation:
8.9.9 Secure the gearbox (1) to the guard ring with the screws (56).
8.9.10 Install the engine as described in section Engine Installation.
8.9.11 Secure the beltguard plate (4) to the engine with the screws (50).
8.9.12 Install the pulley (24) to the input shaft with the key (82), the screw (54),
and the washer (70).
8.9.13 Install the clutch as described in section Replacing the Standard
Clutch.
8.9.14 Install the spider. See section Installing the Spider.
8.9.15 Install the handle. See section Replacing the Lower Handle.
To Next Page
Loading...
Need help?
General
