Guide Handle CT Repair
wc_tx000551gb.fm 64
5.6 Replacing the Twist Pitch Control Cable
See Graphic: wc_gr003363
Disassembly:
5.6.1 Remove the upper handle. See section Replacing the Upper Handle.
5.6.2 Remove the hex head screw (a) from the handle and the socket head
screw (b) from the underside of the twist control assembly (c).
5.6.3 Pull the twist control assembly and the pitch control cable (d) from
handle.
5.6.4 Drive the roll pin (e) from the twist control assembly. Remove the pitch
control cable.
Assembly:
5.6.5 Attach the knob (f) to the twist control assembly (c).
5.6.6 Place the pitch control cable (d) into the twist control assembly and
secure it with the roll pin (e).
5.6.7 Lubricate the threads (g) on the twist control assembly.
5.6.8 Slide the pitch control cable down through the handle and position the
twist control assembly into the upper handle, lining up the holes in the
twist control assembly with those of the handle. Attach the socket head
screw (b) to the underside of the twist control assembly.
5.6.9 Apply Loctite 243 or equivalent to the threads of the hex head screw
(a) and secure it to the handle. Torque the hex head screw to 10 Nm
(7 ft.lbs.).
5.6.10 Replace the upper handle. See section Replacing the Upper Handle.
To Next Page
Loading...
Need help?
General
