BA 1404 en – Edition 2.7 * 1404b340.fm 3-83
Operation
3.37 Grading
Careful when grading –
Accident hazard!
☞ Ensure that no one is in the danger zone when working with the stabilizer
blade
Grading
☞ Lower the stabilizer blade to the ground
– see chapter 3.9 Stabilizer blade operation on page 3-22
☞ Set the depth of the layer you want to remove with the stabilizer blade lever
➥ The machine must not be raised by lowering the stabilizer blade
➥ The clearance between the stabilizer blade and the ground should be about 1 cm (2/
5 in)
To Next Page
Loading...
