3-16 BA 1404 en – Edition 2.7 * * 1404b330.fm
Operation
Starting at low temperatures
☞ Turn the ignition key to position 2 and hold it in this position for about 15 seconds
➥ Engine is preheated
☞ Turn and hold the starting key in position 3 until the engine starts
➥ If the engine does not start after 10 seconds
☞ Interrupt the start procedure and try again after about 1 minute
➥ If the engine still does not start after the second try
☞ Contact a Wacker Neuson service center for troubleshooting
☞ Release the starting key
When the engine runs smoothly (increased engine speed):
In general, a battery delivers less energy in cold conditions. Therefore ensure that
the battery is always well charged.
When the engine has started ...
☞ Check whether the indicator lights go out:
☞ Letting the engine warm up
At cold temperatures:
☞ Increase the engine speed slowly
☞ Do not run the engine at full load until it has reached its operating temperature
Engine warm-up
After the engine has started, allow it to warm up at slightly increased idling speed until it
reaches its operating temperature of 70°C (158°F) (coolant). Run the engine without load
during the warm-up phase (raise the left-hand control lever base). During the warm-up
phase, check for unusual noise, exhaust color, leaks, malfunctions or damage.
In case of malfunctions, damage or leaks, park and secure the machine, and find out the
cause for the damage and have it repaired.
To Next Page
Loading...
Need help?
General
