3-24 BA 1404 en – Edition 2.7 * * 1404b330.fm
Operation
Changing the width of the stabilizer blade
The machine can be damaged if the telescopic travel gear and the stabilizer
blade are set to different widths (for example when driving through a door).
☞ Adjust the stabilizer blade and the telescopic travel gear to the same widths
when operating the machine.
Reducing the width of the stabilizer blade
☞ Raise the stabilizer blade to about 1 – 2 cm (about 0.4" – 0.8").
☞ Pull out pins A on either side.
☞ Turn in the stabilizer blade extensions B on either side.
☞ Insert pins A on either side.
Increasing the width of the stabilizer blade
☞ Raise the stabilizer blade to about 1 – 2 cm (about 0.4" – 0.8").
☞ Pull out pins A on either side.
☞ Turn out the stabilizer blade extensions B on either side.
Insert pins A on either side.
Abb. 64: Changing the width of the stabilizer blade
A
Abb. 65: Changing the width of the stabilizer blade
B
A
Abb. 66: Changing the width of the stabilizer blade
B
A
Abb. 67: Changing the width of the stabilizer blade
A
To Next Page
Loading...
