2-4 BA 1404 en – Edition 2.7 * * 1404b210.fm
Safety instructions
• Before working on or with the machine, remove jewellery, such as rings, wristwatches,
bracelets etc. Tie back long hair and do not wear loose-fitting garments, such as unbut-
toned or unzipped jackets, ties or scarves.
Injury can result from being caught up in the machinery or from rings catching on
moving parts!
• Keep the machine clean. This reduces:
• Fire hazard, for example due to oil-soaked rags lying around
• Injury hazard, for example due to dirt or debris on the footholds, and
• Accident hazard for example due to dirt pile-up on the accelerator pedals
• Observe all safety, warning and information signs and labels on the machine!
• Adhere to prescribed intervals or those specified in the Operator’s Manual for routine
checks/inspections and maintenance work!
• Tools and workshop equipment adapted to the task on hand are absolutely indispen-
sable for performing service, inspection, maintenance or repair work!
Selection and qualification of person-
nel, basic responsibilities
• Any work on or with the machine must be performed by reliable personnel only. Do not
let unauthorized persons perform machine travel or operation! Observe statutory
minimum age limits!
• Employ only trained or instructed personnel on the machine, and clearly and unequivo-
cally define the individual responsibilities of the personnel for operation, set-up, mainte-
nance and repair!
• Define the machine operator’s responsibilities – also with regard to observing traffic
regulations. Give the operator the authority to refuse instructions by third parties that
are contrary to safety.
• Do not allow persons to be trained or instructed or persons taking part in a general
training course to work on or with the machine without being permanently supervised
by an experienced person!
• Work on the electrical system and equipment, on the travel gear and the steering and
braking systems may only be performed by technical personnel that has been specially
trained for such work.
Work on the hydraulic system of the machine must only be performed by personnel
with special knowledge and experience in hydraulic equipment!
• Seal off the danger zone should it not be possible to keep a safe distance.
Stop machine operation if persons do not leave the danger zone in spite of warning!
Keep out of the danger zone!
Danger zone:
The danger zone is the area in which persons are in danger due to the movements of the:
• Machine
• work equipment
• additional equipment or
• material
• This also includes the area affected by falling material, equipment or by debris that is
thrown out.
The danger zone must be extended by 0.5 m (20") in the immediate vicinity of
• buildings
• scaffolds or
• other elements of construction
To Next Page
Loading...
Need help?
General
