Advanced Mapping settings
In Advanced Mapping settings, you can change between Pen mode and Mouse mode. You can also turn on Show
advanced options, which allows you to access advanced mapping features such as selecting a portion of a multi-
display set up or mapping a portion of your device to your display(s).
Topics on this page
Show advanced options
Map your device in Pen mode
Map your device in Mouse mode
Show advanced options(s)
The Show advanced options slider is turned "Off" by default. Turning it "On" enables advanced features -- Select
portion and Use custom area -- in Mapping settings.
Note: Turning Show advanced options "On" is recommended for experienced Wacom
device users.
Map your device in Pen mode
Pen mode is the default mode and the recommended setting for your device. In Pen mode, you use the pen like a
regular pen, and you interact with the device as if it is your paper. Each point on the device maps absolutely to a
specific point on your monitor, and the cursor jumps to the corresponding point on your monitor when you place your
pen on the device.
Note: "Pen mode" is required for mapping your device to your display(s).
1. Open Wacom Center.
2. Select your device in the Devices sidebar.
3. Select Mapping and then click Advanced.
4. Under Mode, select "Pen".
Map your device in Mouse mode
In Mouse mode, you use the pen like a mouse. The cursor stays on the point that you left it when you pick up your
pen, and you interact with your device like you interact with a mousepad or trackpad.
Important: Mouse mode is an advanced feature. Wacom recommends using your device in
Pen mode, which is the default setting.
1. Open Wacom Center.
2. Select your device in the Devices sidebar.
3. Select Mapping and then click Advanced.
4. In the Mode section, select "Mouse".
To Next Page
Loading...
