WAGNER Cobra 40-10 - Using in Accordance with the Instructions; Device Types; Type of Use; For Use in Potentially Explosive Areas

Operating manual High-pressure double diaphragm pumps Cobra 40-10; Cobra 40-25
2 Using in Accordance with the Instructions
Order number 2340851 | Edition 05/2022 9
2 USING IN ACCORDANCE WITH THE INSTRUCTIONS
2.1 DEVICE TYPES
Double diaphragm pump and its spray packs:
Cobra 40-10
Cobra 40-25
2.2 TYPE OF USE
The device is suitable for processing liquid products like paints and lacquers:
– Non-ignitable products.
– Products in accordance with their classification in explosion class IIB.
WAGNER explicitly prohibits any other use!
The device may only be operated under the following conditions:
4 Use the device only to work with the materials recommended by WAGNER.
4 Do not deactivate safety fixtures.
4 Use only WAGNER original spare parts and accessories.
4 The operating personnel must be trained on the basis of this operating manual.
4 Follow the instructions in the operating manual.
2.3 FOR USE IN POTENTIALLY EXPLOSIVE AREAS
The device can be employed in explosion hazard zones (Zone 1) (see Chapter Identification
[811]).
2.4 PROCESSIBLE WORKING MATERIALS
Fluid products like paints and lacquers.
Application Cobra 40-10 Cobra 40-25
Water-dilutable products ↗ ↗
Solvent-based lacquers and paints ↗ ↗
Two-component coating products ↗ ↗
Emulsions ↗ ↗
UV lacquers ↗ ↗
Primers → ↗
Epoxy and polyurethane lacquers, phenolic lacquers ↗ ↗
Liquid plastics → →
Wax-based underside protection ↗ ↗
Shear-sensitive lacquers ↗ ↗
Signs and definitions: ↗ recommended
→ limited suitability
↘ not suitable