WAGNER ProfiTech M - ASSEMBLY AND COMMISSIONING; Training for Assembly Staff; Storage Conditions; Installation Conditions

40
ProfiTech M
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
7 ASSEMBLY AND COMMISSIONING
7.1 TRAINING THE ASSEMBLY STAFF
Incorrect installation/operation!
Risk of injury and damage to the device.
The assembly sta must have all of the technical skills to safely
undertake commissioning.
When assembling and for all work, read and follow the operating
manual and safety regulations for the additionally required
system components.
WARNING
7.2 STORAGE CONDITIONS
Until the point of assembly, the control components must be stored in a dry location, free
from vibrations and with a minimum of dust. The control components gun must be stored
in closed rooms.
The air temperature at the storage location must be between +5 °C and +45 °C; +41 and
+113 °F.
The relative air humidity at the storage location must not exceed 75%.
7.3 INSTALLATION CONDITIONS
The air temperature at the installation site must be between 5 °C and 45°C; 41 °F and
113°F.
Depending on the powder lacquer used, the maximum permissible ambient temperature
for reliable operation can be signi cantly below 40 °C; 104 °F.
The relative air humidity at the assembly location must not exceed 75%.
A skilled person must check to ensure that the device is in a reliable state after it is installed
and commissioned.