WAGNER ProfiTech M - ASSEMBLY OF CML720 I LIGHT CURTAINS; Assembly of CML720 i Light Curtains

62
ProfiTech M
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
7.13.4 ASSEMBLY OF CML720I LIGHT CURTAINS
Please note the assembly and installation instructions provided by the manufacturer.
These can be downloaded from http://www.leuze-electronic.de.
Light curtain assembly:
Note:
No re ective surfaces, no mutual interference!
Avoid re ective surfaces near the light curtains.
Otherwise the objects may not be detected with accuracy as a result of re ection.
Ensure su cient spacing, appropriate positioning or partitioning.
Optical sensors (e.g. light curtains, light barriers etc.) must not interfere with one
another.
Avoid allowing the receivers to be exposed to strong external light (e.g.  ash lamps,
direct sunlight).
This can be achieved with su cient spacing, appropriate positioning or partitioning.
1. Select the type of fastening for transmitter and receiver.
- Fastening using T groove on one side of the standard pro le.
- Fastening using swivel mount on face ends of pro le.
- Fastening using swivel / parallel holders.
2. Keep appropriate tools at hand and observe the information relating to the assembly
locations while  tting the sensors.
3. Fit transmitter and receiver level and with no distortion at the same height and/or with
the same housing reference edge.
Note:
Attention!
If sensors 2 m in length or longer are  tted horizontally, use an extra fastening in the
center of the sensor.
The optical surfaces of the transmitter and receiver must be parallel with one another.
The transmitter and receiver connections must be facing in the same direction.
4. Secure transmitter and receiver so that they can't twist or move.