55
ProfiTech M
P_02181
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
7.11 POWER SUPPLY OF THE EPG CONTROL UNITS
The power supply 230 VAC for the EPG S2 takes place via the X30 clamps: 11-13 (EPG 1) and
X30: 14-16 (EPG 2).
The same clamps can be used for the supply of the EPG Sprint X.
A maximum of 10 EPG control units can be connected to a group.
The voltage on both clamps is secured via both circuit breakers F2A and F2B and switched
via relay K3.
EPG
Group 1
EPG
Group 2
To Next Page
Loading...
