97
ProfiTech M
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
11 DISASSEMBLY AND DISPOSAL
11.1 DISASSEMBLY
WARNING
Incorrect disassembly!
Risk of injury and damage to the device.
Before starting disassembly:
- Switch o the energy/compressed air supply.
- Ensure that all system components are grounded.
- Secure system against being switched back on without
authorization.
Observe the operating manuals for any work.
We recommend having the Wagner system disassembled by Wagner or another specialist.
Before starting disassembly, all supply media (electric current, compressed air) must be
disconnected at the connection points. All powder lacquer lines must be completely
emptied and then rinsed. Lacquer residues must be disposed of in line with statutory
requirements.
Before starting disassembly, check whether the supply lines have actually been interrupted
and have been depressurized and/or de-energized if necessary.
The empty system should be thoroughly cleaned. In particular re loads such as unused
lacquers in exhaust air pipes etc. should be removed to keep the risk of re during
disassembly as low as possible.
We recommend reporting to the public authorities the fact that systems with mandatory
approval requirements are decommissioned.
Separate all materials encountered during disassembly as clearly as possible in line with
statutory requirements. Take appropriate actions to ensure that no dangerous substances
enter the system during disassembly. All waste produced must be separated and disposed
of in line with local requirements.
Used materials are:
- Steel
- PVC plastics
- Cable
To Next Page
