82
ProfiTech M
Rdcba6432168421
P_01990
P_02512
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
7.15.4 SETTING NODE ID AND BAUD RATE ON RECIPROCATOR
The CAN node ID has to be set on the reciprocator's frequency converter.
The setting takes place via the DIP switch 1-64.
Setting reciprocator 1: Adress 21 (DIP switch 1,3,5 ON)
Setting reciprocator 2: Adress 22 (DIP switch 2, 3, 5 ON)
Further reciprocators will be consecutively numbered (23, 24; ...).
on
o
Address: 21
Baud rate: 250
Terminating resistor: OFF
The baud rate can be set with switches a to d.
The value is set to 250 KB (switch a ON) in the factory.
On the last device of the CAN loop, switch R has to be set to ON.
To Next Page
Loading...
