63
ProfiTech M
P_02463
OPERATING MANUAL
VERSION 07/2014 ORDER NUMBER DOC 2335144
Fastening using swivel mount
If assembling with the BT-2R1 swivel mount (needs to be ordered separately), the sensor
can be adjusted as follows:
Slide through the vertical slots in the swivel mount's wall plate
Rotate 360° around the longitudinal axis by xing on the screw-on cone
Tilt around the depth axis
Tip through horizontal slots in the wall fastening
If fastened to the wall using the slots, the mount can be raised above the connection cap
once the screws have been unscrewed.
The mounts do not therefore have to be removed from the wall when the device is replaced.
Unscrewing the screws is su cient.
To Next Page
Loading...
