Safety information
12 Lexa PLUS| Instructions for Use |RIS-311 ENG Rev03 |29/08/2022 |© W&H Sterilization Srl
CONTENTS
This section deals with the following subjects:
Safety warnings 12
Responsibility 14
Safety warnings
THERMAL HAZARDS
n The chamber automatically begins to heat to
high temperature as soon as the sterilizer is
switched on – risk of burns!
n The trays and the sterilization load are hot at
the end of each cycle. Use tray or cassette
holders to empty the sterilization chamber.
n Always wear appropriate PPE during use of the
sterilizer (e.g. gloves for cleaning, maintenance,
etc...).
ELECTRICAL RISKS
n Do not pour water or any other liquids over the
sterilizer (risk of electrical short circuits).
n Switch off the sterilizer and unplug the mains
cable before inspecting, carrying out
maintenance or servicing the sterilizer.
n Ensure that the power receptacle the sterilizer
is connected to is properly grounded.
n All electric devices connected to the sterilizer
shall be of Insulation Class II (double insulated)
or higher.
n Use only the power cord provided by the
manufacturer.
IMPROPER USE OF THE STERILIZER
n The sterilizer must not be used in presence of
explosive or flammable gases, vapors, liquids
or solids.
n The sterilizer has not been designed for the
sterilization of foodstuff or waste.
n Do not exceed the maximum load weight limits
as specified in this manual (see "Run a
sterilization cycle" on page54).
n Do not drink any water that has been inside the
sterilizer.
To Next Page
Loading...
