W&H Lexa PLUS - Table of Contents

Table of contents
Lexa PLUS| Instructions for Use |RIS-311 ENG Rev03 |29/08/2022 |© W&H Sterilization Srl iii
Conformity 5
Symbols and messages 6
Introduction 8
About this manual 8
Use restrictions 9
Safety information 12
Safety warnings 12
Responsibility 14
Getting started 15
Unpacking 15
Handling 18
Product description 19
Installing the sterilizer 23
Operating the sterilizer 27
User interface menu 28
Sterilizer setup 34
User authentication (optional) 35
EliTrace (optional) 36
USB pen drive 36
Standby mode 37
Administrator 38
User management (optional) 38
Traceability options (optional) 39
Hide/Unhide a cycle 40
Managing printers 41
Printer selection (optional) 41
Label printer selection (optional) 41
Label printer usage (optional) 42
Label content description 44
Sterilizer tests 45
Sterilizer performance tests 45
Bowie and Dick test 45
Vacuum test 47
Sterilization cycles 49
Load maintenance and preparation 49
Typical loads 51
Prepare the sterilizer 52
Sterilization cycle description 53
Sterilization cycle management 54
Unloading 59
Sterilization cycle report 59
Maintenance 64
Warnings for maintenance operations 64
User maintenance 64
Monthly or 50-cycle maintenance 66
400-cycle maintenance 69