W&H Lexa PLUS - User Authentication (Optional)

Lexa PLUS| Instructions for Use |RIS-311 ENG Rev03 |29/08/2022 |© W&H Sterilization Srl 35
Getting started
CONNECT TO A NETWORK
If you connect through an Ethernet cable, in most cases the sterilizer
will connect to the network automatically. If it does not connect
automatically, or if you are using a Wi-Fi dongle key, follow the
following procedure under supervision of your IT manager / network
administrator.
 1 On the homepage, tap > > .
 2 If the connection is through the Ethernet cable, tap : the
TCP/IP screen appears.
 3 If the connection is through Wi-Fi dongle key, tap : after a
while, the sterilizer shows the available networks found. Choose
the network, enter the credentials in the following screen, then
tap to confirm:the TCP/IP screen appears.
Note: the and icons are disabled if the connectivity means
(cable or Wi-Fi dongle key) are not properly plugged.
Note: in the TPC/IP screen, the icon is visible only if you make
any change. The Wi-Fi icon at the bottom isn't visible if you connect
through Ethernet cable.
 4 If your network supports dynamic IP addresses (ask your
ITmanager), enable the options Dynamic both in IP
Configuration and in the DNS Configuration fields, then tap
to confirm: all entry fields are disabled.
 5 If your network does not support dynamic IP addresses (ask
your ITmanager), enable the options Static both in IP
Configuration and in the DNS Configuration fields. Tap on
each entry field and enter the IP addresses (ask your IT
manager for details). Then tap to confirm.
User authentication (optional)
FUNCTION AVAILABILITY
To access the user management functions a special code must be
entered. The special code is required only at the first access to the
User Management ( ) menu: after the code was entered, the
function is enabled and there is no need to enter the code again.
If you want to disable the function another special code must be
entered.
Note: for more information contact your dealer.
PIN MANAGEMENT
PIN “0000” is assigned as default to each new user. It has to be
changed at the first login. When the PIN is reset the default value
“0000” is reassigned.
CHANGE YOUR PIN
Change your PIN the first time you use the sterilizer and if your PIN
has been reset. This will prevent other users to use your account.