W&H Lexa PLUS - Page 43

Lexa PLUS| Instructions for Use |RIS-311 ENG Rev03 |29/08/2022 |© W&H Sterilization Srl 43
Managing printers
code, please refer to the activation code instructions provided with
the label printer.
AUTOMATIC PRINTING OPTION
The automatic printing option permits to automatically print a preset
number of labels after a successful sterilization cycle. The labels are
printed only after the user has identified him/herself (with password
if required) and the load has been checked and released, if these
options have been enabled by the administrator.
For the automatic label printing, a maximum storage time in weeks
can be set. This value is used to calculate the expiry date to be
printed on the labels (see "Label content description" on the next
page).
SET THE AUTOMATIC LABEL PRINTING
 1 On the homepage, tap > > >
 2
Activate Automatic printing.
 3 Tap or to set the maximum storage time and the number
of labels to be printed automatically.
 4 Tap to confirm and go back to the previous page.
SET THE MANUAL LABEL PRINTING
The manual printing option permits the user at the beginning of a
sterilization cycle to set manually the number of labels to print.
 1 On the homepage, tap > > >
 2
Activate Manual printing.
 3 Tap to confirm and go back to the previous page.
DISABLE THE LABEL PRINTING
If the label printing is disabled, no label can be printed at the end of
a sterilization cycle.
 1 On the homepage, tap > > >
 2
Activate Disabled.
 3 Tap to confirm and go back to the previous page.