Waters 2545 Binary Gradient Module User Manual

Installing the binary gradient module 1-5
Frequency 50/60 Hz
Current requirements,
fusing
10 A, 5 × 20 mm, slow-blow, IEC type
Power consumption 650 W
Warning: System configurations are designed to meet safety and
performance standards. All systems must adhere to a model in which any one
“base” Waters module (i.e., the System Fluidics Organizer, the 2545 Binary
Gradient Module, or the 3100 Mass Detector) supports no more than two
vertically oriented “accessory” Waters modules (e.g., 515 pumps, photodiode
array detectors, evaporative light scattering detectors, or dual wavelength
absorbance detectors). Configuring modules in such a way that fails to meet
said design is neither recommended nor supported by Waters Corporation.
When configurations require module stacking outside the noted parameters,
the customer assumes liability.
Site requirements (Continued)
Factor Requirement

Waters 2545 Binary Gradient Module Specifications

General

Brand	Waters
Model	2545 Binary Gradient Module
Category	Control Unit
Language	English