Waters 2545 Binary Gradient Module User Manual

Configuring 515 pumps 2-7
Defining 515 pump parameters
9. For each 515 pump, enter the initial flow rate, and select the solvent
name. The default flow rate is 1.00 mL/min.
Tip: You can change the low and high pressure limits for each 515 pump.
10. Click OK.
Requirement: For each 515 pump that is not a contributor to the system
flow (makeup pump), in the Events table, you must program the flow
rate, start flow, and stop flow events.

Waters 2545 Binary Gradient Module Specifications

General

Brand	Waters
Model	2545 Binary Gradient Module
Category	Control Unit
Language	English